74
•
Interface Type
: Choose
PPP (vcc1)
– depending on the inter face; typically vcc1 for
DSL – or
IP Address
from the pull-down menu to specify whether the static route is
accessible through PPP or IP address.
•
Gateway
: Enter the IP address of the gateway for the static route. The default gateway
must be located on a network connected to your Netopia Gateway configured inter face.
•
Metric
: Specifies the hop count for the static route. Enter a number from 1 to 15 to indi-
cate the number of routes (actual or best guess) a packet must traverse to reach the
remote network. Some metric or a value of 1 will be used to indicate:
• The remote network is one router away and the static route is the best way to
reach it.
• The remote network is more than one router away but the static route should not
be replaced by a dynamic route, even if the dynamic route is more efficient.
•
RIP Advertise
: From the pull-down menu, choose how the static route should be adver-
tised via RIP:
•
Split Horizon
: Do not adver tise route if the gateway is on the same subnet.
•
Always
: Adver tise route in all RIP messages.
•
Never
: Do not adver tise route.
Click the
Submit
button. The Aler t icon
will appear, so that you can switch to the
Save Changes
page, when you are finished.
Once you save your changes, you will be returned to the IP Static Routes entr y screen.
•
You can continue to
Add
,
Edit
, or
Delete
Static Routes from this screen.
Summary of Contents for 3342
