Using Your Spire Terminal
Turn the terminal on by pressing the power button until the screen lights up. You will need
to enter your full merchant ID on first installation and you will also need to create a 5 digit
security code. This code cannot be sequential (i.e. 12345). The terminal will automatically
scroll through several screens of information until the Welcome screen
is displayed.
To turn the terminal off press the power button for three seconds, ensure SHUTDOWN
is highlighted and press the green ENTER key.
PLEASE NOTE: Highlighting RE-START will re-start the payment application.
Changing and replacing the battery on SPw60 and SPg7 terminals
If you have a portable terminal it will use a removable, rechargeable lithium ion battery
module. The battery module will need to be charged when you receive a new terminal,
a replacement battery, and during day-to-day use.
Battery Module Installation and Replacement
1. Place the terminal face down on the counter and remove the battery cover by applying
pressure and sliding it backwards as shown below.
2.
If a battery module is already fitted, place your thumb nail into the recess at the base
and pull upwards. The battery module will lift out of the compartment. See section
‘Safety Information and Battery Guarantee’ in the introduction for battery module
disposal instructions.
3.
Remove the packaging from the new battery module and ensure the connections are
aligned with those in the battery compartment. The Spire Payments logo should be
facing upwards.
4.
With the contacts aligned, insert the module into the battery compartment by pushing
downwards.
5.
Slide the battery compartment cover back into position.
10 Using Your Spire Terminal
intelligent payments
