Installation
Getting Started – New NetPilot Range
16
Caution:
Do not disconnect electrical power from the NetPilot until shut
down is completed.
Only use the power cable supplied with the unit to connect to the
mains power supply. Do not use any other power cable with this
unit. If the plug on the power cable does not match the mains inlet
socket, contact your reseller for further advice.
LAN 1
The 10/100 or 10/100/1000 Ethernet Base-T interface is an
RJ45 socket.It allows direct connection between the
NetPilot and a single piece of equipment. The Ethernet LAN
port simulates the characteristics of a workstation port. This
allows it to be directly connected to a LAN or network hub
port as required.
LAN 2
The 10/100 or 10/100/1000Base-T interface is an RJ45
socket and it is recommended as the connection to an
outside network i.e. Internet. It allows direct connection
between the NetPilot and a single piece of equipment for
example ADSL router or a LAN or network hub port as
required.
LAN 3
10/100 or 10/100/1000 Base-T interface with an RJ45
socket. NetPilot V6 software this is a configurable port for
DMZ or additional LAN use.
Monitor
Initial Configuration and diagnostic use only
Keyboard
Initial Configuration and diagnostic use only
N.B.
All other ports are for diagnostic or future use and not
customer configurable or usable.