Installation
Getting Started – New NetPilot Range
17
Installation
Power connection
Connect the power lead provided to the power connector on the rear
panel of the NetPilot and to a standard mains wall socket.
Do not switch on
at this stage.
Only use the power cable supplied with the unit to connect to the
mains supply. Do not use any other power cable with the NetPilot.
If the plug on the power cable does not match the mains socket,
contact your supplier for further advice.
LAN connection
The connection to the 10/100 or 10/100/1000 Base-T Local Area
Network (LAN) may be to a hub or switch, or for diagnostic purposes
directly to a single workstation or PC.
Do not connect an ISDN line to a NetPilot LAN port. The ISDN
voltage can damage the unit.
Connecting to a hub or switch
1.
Connect either end of the supplied cable to the
LAN 1
socket on the
NetPilot.
2.
Connect the other end of the cable to a hub or switch port.
Connecting to a single PC
1.
Connect either end of the cable to the
LAN 1
socket on the NetPilot.
2.
Connect the other end of the cable to the socket on the PC’s
Ethernet adaptor: