[ENG] NetPing 2 IP PDU ETH 53R14 & NetPing 2 IP PDU GSM3G 203R15, User guide -[ENG][2PWR] Connecting External Sensors
and Accessories
[ENG][2PWR] Connecting External Sensors and Accessories
–
[ENG][2PWR] Connecting External Sensors and Accessories
The description of contacts
In order to connect sensors to the device conveniently, use the terminal block. Use a slotted screwdriver with a slot
width of 2.5 mm to secure the wires in the terminal block. The pinout of the contacts on the terminal block is as
follows:
Contact
Description
I1-I4
IO-line 1–4
It is prohibited to plug sensors and external modules into NetPing devices when a power supply is on!
You can find the information about configuration of the device and receiving notifications from sensors in the
document:
«User Guide».