[ENG] NetPing 2 IP PDU ETH 53R14 & NetPing 2 IP PDU GSM3G 203R15, User guide -[ENG][2PWR] Connecting External Sensors
and Accessories
[ENG][2PWR] Connecting External Sensors and Accessories
–
•
•
•
•
Sensors of the "Dry contact" type
The number of connected dry contact sensors is limited by free IO lines of the device and the total current
consumption of the sensors, if they require additional power.
If the sensor needs extra +12 V power, you need to use one of the input / output lines in the "output" mode. Thus, it
is possible to control the power of the sensor additionally using a logical level on the line. This can be useful, for
example, in the case of sensors whose alarm is reset by removing power.
Two wire sensors
Sensors and other signal sources which do not require additional power or they are powered from other power
sources and it is isolated from the signal line, connected to the IO and GND terminals of the device. The polarity of
the connection is important unless otherwise directly indicated in the documentation for the sensor.
Such type of sensors include:
Supply voltage sensor
NetPing Supply Voltage Sensor 995S2
(N.Z. and N.O. contacts (3 wires in total) - see the sensor
documentation for details);
Air Flow Sensor (model AMC520)
Sensor Loop
Device Terminal
Green
I1-I4
Yellow
G
Brown
+
White
G
Attention!
There are 12 V, up to 200 mA
on the input / output lines of the device (IO1-IO4) in the “output”
mode, . If used improperly, the connected equipment may fail.
If the factory cable length is not enough, it can be increased by using
, which are connected to
each other
, or independently using any wire with a cross section of at least 0.4 mm2.
sequentially
sequentially
sequentially
sequentially
If the factory cable length is not enough, it can be increased by using
, which are connected to
each other
, or independently using any wire with a cross section of at least 0.4 mm2.
sequentially
sequentially
sequentially
sequentially
The maximum permissible loop length is 100 meters.
The maximum permissible loop length is 100 meters.
The corresponding IO line to which the signal wire from the sensor is connected must be switched to the
“input” mode in the device settings.