NetPing 3802, User Manual

[ENG] NetPing Infra Red Universal Remote Control 3802, User guide -[ENG] [IR3801] Installation and Connection

[ENG] [IR3801] Installation and Connection

                             – 

2.  Start recording the command to the required channel in the device web interface according to the 

documentation (

[ENG] 4.1. [DKSF 38.1 IU] How to write IR-commands Correctly?

). In this case, the CPU LED on the 

second Ethernet connector will light up continuously.

3. Press the button on the remote control for a short period of time, the command from which you want to record. 
After a successful reading, the CPU LED on the second Ethernet port will turn off.

4. If possible, in order to check, direct the device with IR transmitters (outgoing arrows) to the target device and test 
the command which has just been recorded.

Step 3. Mounting and sensors connection

1. Mount the device using the standard mount on a surface in the line of sight of the IR receiver of the device you 
want to control.

2. Using the mount rotary joint, direct the device with the IR transmitters to the controlled device.

3. According to the documentation (

Connecting Sensors

), connect all necessary sensors to the device..