NetPing server room environmental monitoring solutions and IP power distribution units.
Copyright © NetPing east Co., Ltd / E-mail:
/ Phone: +886-2-23121582
support@netpingdevice.com www.netpingdevice.com
SxR
Return to the primary input for outlets group x, where x is the number of outlet group: 1 (outlets 1 ... 4) or 2 (outlets 5 ... 8)
Lm+
Set the line m to log. 1, where m is the number of the IO line.
Lm-
Set the line m to log.0, where m is the number of the IO line (1...4).
LmP
Give an impulse to the line m, where m is the number of the IO line (1...4)
Lm?
Request the state of the line m, where m is the number of the IO line (1...4)
L?
Request the status of all IO lines in a short form.
N?
Request the pinger status
Ka
Send the IR command through the
, where a is a number of a command
Tb?
Request the values of a Temperature Sensor b, where b - is a number of a Temperature Sensor
Hb?
Request the values of a Humidity Sensor, where b - is a number of a Humidity Sensor.
T?
Request the values of all connected Temperature Sensors in a short form.The sign of connectivity is a specified 1 wire address.
H?
Request the values of all connected Humidity Sensors in a short form.The sign of connectivity is a specified 1 wire address.
RB20
Reboot the device. The reboot will occur in 20 seconds after receiving a command.
THE EXAMPLES OF SMS COMMAMDS
Switch on command of the relay of 1 device:
REPLY MESSAGES TO SMS COMMANDS
Confirmation of the command execution, such as switching a relay or changing a state of a discrete output line:
where:
fff — is the code of the original command, which execution is confirmed by this message. For example, P1+;
kkkkk — a request identifier (arbitrary number from 3 to 9 digits). It is repeated in the response to establish the correspondence between the
request and the response. An optional command element. If the identifier is not in the command, you can not see it in the response.
An error occurred while the device is taking it. Most likely it is the wrong text of the original command:
where:
original command — the text of the original command fully quoted
Wring password (Community) in an original command:
NETPING P1+ SWITCH
NP DONE fff kkkkkk
NP DONE fff
NP WRONG CMD: «original command»
NP WRONG PASSWD IN kkkkkk
NP WRONG PASSWD
