NetPing server room environmental monitoring solutions and IP power distribution units.
Copyright © NetPing east Co., Ltd / E-mail:
/ Phone: +886-2-23121582
support@netpingdevice.com www.netpingdevice.com
[ENG] 3.10. [DKSF 48.5 IU] How to Receive Notifications and Reports via Email?
To configure the module for sending e-mail notifications and reports about a status, there is a need to go to the page «
» of a web
interface. The equipment sends notifications using an SMTP protocol.
where:
when unchecking the checkbox a device will not send e-mail notifications. This was designed, first of all, to handle
Enable Sending of E-mail –
maintenance in a server room, as well as the one of the equipment. On default: checkbox is not checked
is an email address for an incoming mail.
SMTP Server Address –
On default: empty line
is an email server port, which works via an SMTP protocol.
SMTP Server TCP Port –
On default: 25
is a username of an SMTP server.
Username –
On default: empty line
is a password of an SMTP server user.
Password –
On default: empty line
a sender's address.
From –
On default: empty line
a destination address for e-mail notifications.
To –
On default: empty line
addresses of secondary recipients for e-mail notifications, to whom a copy is sent.
Copy To (сс:) –
On default: empty line
is a time when reports on a status of sensors
Time for Summary Reports (HH:MM 24h format, up to 12 time points, divided by space) –
will be
via e-mail.
sent
On default: empty line
After setting the parameters, click the button «Apply changes».
You can add a display of the device name in the email notification. You can find wow to do it on the page «
[ENG] 3.1. [DKSF 48.5 IU] How to
Configure a Hostname, a Location and Contact?
Events, on which e-mail notifications will be sent, are set at other pages of a device web interface.
The device works only with the email servers that support an SMTP-protocol and authentication methods AUTH PLAIN and AUTH
LOGIN, as well as a no-authentication method! At the same time, the device does not support SSL, TLS or any other encoding!
