&KDSWHU&RQILJXULQJWKH1HW6FUHHQIRUWKH)LUVW7LPH
1HW6FUHHQ
$OORZLQJ2XWERXQG7UDIILF
By default, the NetScreen-10/100 does not allow inbound or outbound traffic. You
need to create an outgoing Access Policy to permit outbound traffic to traverse the
firewall.
1. Click the New Policy link in the lower left corner of the page.
The Policy Configuration dialog box appears, as shown in Figure 3-6 “Policy
Configuration Dialog Box” on page 3-6.
Figure 3-6 Policy Configuration Dialog Box
2. Set an Access Policy that allows all inside hosts to access the Internet. Set
the options as follows:
– Name: This is optional.
– Source Address: Inside Any (Inside Any is a predefined address for all
hosts on the Trusted network.)
– Destination Address: Outside Any (Outside Any is a predefined address
for all locations on the Untrusted network, usually the Internet.)
– Service: Any (Any is a predefined value for any IP service.)
Summary of Contents for NetScreen-10 Series
