32
How to Move the Finishing Trim
continued
Procedure,
continued
6. Reinstall the horizontal trim to the opposite side of the
enclosure.
a. Insert the studs on the horizontal trim through the mount-
ing hole in the horizontal trim, and then through the
appropriate hole in the frame of the enclosure. Replace
the hex nut loosely on the screw.
b. Repeat the step above for the other studs on the horizon-
tal trim.
Note
: Make sure that the small ear at the end of the hori-
zontal trim is hooked over the top of the vertical
trim.
c. Tighten the nuts securing the horizontal trim to the
enclosure assembly.
7. Repeat steps 4–6 for the rear of the cabinet. To install the
brackets, use the countersunk screws previously removed
from the front door bumpers and latch plates. Use the
socket-head screws previously used to secure the trim.
8. Reinstall any side panels required. (See page 13.)
9. Reinstall the roof of the enclosure. Replace the four socket-
head screws with the 5 mm Allen wrench (included).
Summary of Contents for AR1000A
Page 1: ...NetShelter Premium Enclosure AR1000A AR1001A AR1100A User s Manual...
Page 6: ......
Page 42: ......
Page 43: ......