(2)
Scanning the following barcode will restore the scanner to the factory.
Scanner will power off after you scanning Factory Restore.
Warning Tone
：
· Red Light - Charging
· Green Light - Fully charged
Get Battery Volume
Barcode Programming:
Scan below command barcode to get battery rough volume.
Netum barcode scanners are factory programmed for the most common terminal and
communication settings. If you need to change these settings, programming is
accomplished by scanning the barcodes in this guide. An asterisk (*) next to an option
indicates the default setting.
1) Voltage < 3.5V - Low battery Volume
There will have 5 beeps after each scan. Scanner can not be able to read any barcodes.
2) 3.7V< Voltage < 3.5V- Low battery Volume
There will have 2 beeps after each scan.
3) Voltage >4.2V , Full Volume
%#IFSNO$B
Factory Restore
Factory Defaults
%BAT_VOL#
