NT-1200
Quick Setup Guide
This is a plug and play model if you use a US keyboard. If you use other type of keyboard, plug the
USB cable on your device , setup keyboard language before you use it. (refer to below Keyboard
Language Type) after that the scanner can start to work.
If you want to do other configurations please refer to below programming barcodes.
Barcode Programming
Netum barcode scanners are factory programmed for common terminal and communications
settings. If you need to change these settings, programming is accomplished by scanning the bar
codes in this guide. An asterisk (*) next to an option indicates the default setting.
Firmware Version
Read below command barcode to check scanner firmware version.
000A0
Firmware Version
Please advise the scanner model number and firmware version when you have any inquiry about
the scanner.