NetUP Streamer HDMI 1x v2. User manual
15
Parameters → IP stream:
From the menu on left side of the webpage, clicking “IP stream”, it displays the interface where users can configure
current the IP stream parameters (Figure-6).
Pls note: RTMP protocol only can be configuration in the webpage management
Figure-6
Parameters → OSD:
From the menu on left side of the webpage, clicking “OSD”, it displays the interface where users can configure OSD
parameters for the RF output.
Parameters → USB:
From the menu on left side of the webpage, clicking “USB”, it displays the interface where users can operate USB device.
(Figure-8)
NOTE
: It is necessary to connect USB device and signal source and activate encoding to operate TS recording.
NOTE
: It is necessary to connect USB device when operate TS playing.
Figure-8
Detailed Explanation:
There are 3 File save modes provided:
⚫
“Single file”: For example, when the file size is set as 1000M and the *.ts is recorded up to 1000M, it automatically stops
recording TS.
⚫
“Segment file”: For example, when the file size is set as 1000M and the *.ts is recorded up to 1000M, it automatically
saves the files and continues to record TS and save it to next file until the USB memory is full.
⚫
“Loop record”: It automatically saves the files and continues to record TS and save it to next file. When the USB memory
is full, it replaces the previous file.
File Size: users can set the file size for the *.ts to be recorded. A single file can be maximum 2000M in size.
Support RTMP
protocol
Configure TS file
parameters and click
‘Start record’ to start
recording.
Configure TS playing
parameters and click
‘Start play’ to start
playing TS files.
