DVR Server Manual
41
First, you should select the PTZ camera and set the preset. Then, you
should select the detected camera, which is showed as
. Next,
select the detected area named Zone01 like the green frame. If you select the
number is 64, the total of the zone is 64, you can detect the number of areas is
64. When the detected area motions, the PTZ camera will link to the preset you
set.
(3).
Motion Setup
If you don’t want to use the motion link PTZ preset function, you should
press
again, then the motion detection is enable as below:
By default, the entire screen is set as motion detection area where is
indicated with green border around the image. To mask a specific area, you
can click
button to cancel the full screen detection border; then
Left-Single-Click and drag a rectangle to mark the area. A green rectangle will
mark the area of it. Also, you can set any other areas. Any activities in the
motion detection areas will trigger recording, depending on the reaction mode;
and alarms may be generated along with electronic map icons flashing in alert
mode. Click
button to test the sensitivity of motion detection. The
sensitivity can be adjusted by dragging the slider bars below the motion
detection window.
