6
5. Data Report
After power on, the device will immediately send a version packet report and two data reports including CO2, temperature,
humidity and voltage.
The device sends data according to the default configuration before any other configuring.
ReportMaxTime
:
RA0715 and RA0715Y is 900s,
R72615 is 1800s (subject to original setting)
* MaxTime
cannot
be set less than 15 min
* The value of the ReportMaxTime should be
greater than ReportType count *Report10
ReportMinTime
:
30s (US915, AU915, KR920, AS923, IN865)
120s (EU868)
ReportType count
:
2
Note:
(1) The cycle of the device sending the data report is according to the default.
(2) The interval between two reports must be the MaxTime.
(3) ReportChange is not supported by RA0715_R72615_RA0715Y (Invalid configuration).
The data report is sent
according to ReportMaxTime as a cycle (the first data report is the start to the end of a cycle).
(4) Data pocket: CO
2
, temperature, and humidity.
(5) The CO
2
sensor operates stably. It takes about 180 seconds after power-on to send the data report.
(6) The device also supports the TxPeriod cycle configuration instructions of Cayenne. Therefore, the device can
perform the report according to the TxPeriod cycle. The particular report cycle is ReportMaxTime or TxPeriod
depending on which report cycle was configured last time.
(7) It would take 180 seconds for the sensor to sample and process the collected value after pressing the button,
please be patient.
The device reported data parsing please refer to
Netvox LoraWAN Application Command document
and
Netvox Lora
Command Resolver
http://loraresolver.netvoxcloud.com:8888/page/index
