9
3)
We do not recommend to set the MinTime Interval value too low. If the MinTime Interval is too low, the device wakes up
frequently and the battery will be drained soon.
4)
Whenever the device sends a report, no matter resulting from data variation, button pushed or MaxTime interval, another cycle of
MinTime/MaxTime calculation is started.
6.
Installation
1.
Use the attached 3M rubber pad, stick one side to the
Wireless 3-Gang Push Button (RB02C), and stick the
other side to the wall.
2.
To make the installation firmer, please use screws
(purchased separately) to fix the device to the wall.
* Note:
⚫
Please don't stick it on the rough wall to avoid the device
from falling off after the long-term usage.
⚫
If use the supplied 3M rubber pad, please wipe the wall
clean before installation to avoid dust on the wall and affect
the effect of the paste.
⚫
The middle part of the 3M rubber pad (the part with the
red frame in the left picture below) is where the label is
attached to the device. Please remove the rubber pad that
has been cut.
⚫
Do not install the device in a metal shielded box or in an
environment surrounded by other electrical equipment to
avoid affecting the wireless transmission of the device.
3.Install the battery in the battery slot, and close the snap-fit
joint of the device, as shown in the figure below.
*Note:
If user wants to open the snap-fit joint, user can pry it
gently.
RB02C can be applied to the following scenarios:
⚫
Home (bathroom)
⚫
School
⚫
Nursing home
⚫
Hospital
⚫
Bank
⚫
Hotel
The place where an emergency may occur.
3. When the button of the device is pressed, the device will send
button status.
When the device periodically reports data next time, it restores the
"normal" state and sends the "normal" state information.
When button pressing, the bit of data is "1".
When button no pressing, the bit of data is "0".
3M Rubber Pad
Screw holes
Snap-fit Joint
