Resetting Power Consumption Summation
Z809B updates and stores the last energy reading in kwh. In some cases user would wish
to return the counter to zero. Same feature can be found in ZiG-BUTLER software with the
Recalculate
button.
Operation:
Hold press Binding Key for 20 seconds then release the key when the
green
network
indicator flashes 4 times,
within 2 seconds
, short press the button switch once. If
successful the
green
network indicator will flash once.
Restore to factory setting
Z809B is capable of storing and saving includes network routing information. If you wish to
remove Z809B from an exited network, you would need to clear the saved routing
information to join to a new network by simply reset the device to restore to the factory
setting.
*notes: restore Z809B back to factory default will not reset power consumption summation.
Please refer to
Resetting Power Consumption Summation
section above.
Operation
1. While the device is given power,
hold press
the binding key for 15 seconds then
release the key when the
green
network indicator flashes 3 times then,
within 2 seconds
,
short press the button switch once.
2. If restore to factory setting is successful, you should see the indicator light flashes 10
times.
Soon the device will reboot by itself. In so the entire ZigBee network and required
information is cleared. It will enter network search to attempt to join to a network. Refer to
network association
section of this manual.
Power Overload
Upon detecting current exceeds 5A, the output will be switched off within 30 seconds.
