4
3. Specification
Fully IEEE 802.15.4 compliant
Utilizes 2.4GHz ISM band; up to 16 channels
2*AAA alkaline battery
Communication range up to 210 meters
4. Installation
This device is NOT truly waterproof/ resistant and is for indoor use.
5. Setting up ZA02A
5-1. Join the ZigBee Network
After ZA02A is turned on, it will search for an existing ZigBee network with the same channel and send a
request to join the network automatically. While ZA02A is under the coverage from a coordinator or a router
whose
permit-join feature is enabled
, ZA02A will be permitted to join the network.
1. Enable the permit-join function (valid for 60 seconds) of a coordinator or a router (please refer to the user
manual of the coordinator or the router to enable the permit-join feature).
2. Load batteries on ZA02A. It will start to search and join the network.
3. The green indicator will flash for 5 times slowly after joining successfully.
4. If it is fail to join network within 3 minutes, device will enter sleeping mode and search/join network every
15 minutes.
5. During sleeping mode, press and hold binding key for 3 seconds or press shortly once (the buzzer rings 3
times) to search/join network.
5.2. Enroll in the ZigBee Security System
ZA02A is a Zone device in the ZigBee security system. Right after ZA02A join the ZigBee network, it will
automatically find out a CIE (Control and Indicating Equipment) device (i.e. Netvox Z201B) and send a
registration request to the CIE device to enroll in the security system. The enrollment has these 3 situations: