100
Startup error messages
[DRAM]
Running on CPU0, on memory
segment 0 (that is, program is now
running in RAM rather than flash
memory).
If the system stops on one of these
error codes, the memory is bad or
the NVLOG subsystem
malfunctioned. To test this, reseat
the DIMM and disconnect the
battery. See “
If that fails to clear the problem,
replace the DIMM. See “
the SDRAM DIMM on the CPU
module
[Zero]
Zero memory…no NVMEM.
[Keep]
Keep memory…preserve NVMEM.
[ZBSS]
Zero the BSS segment.
[CODE]
Zero and copy the code segment
from flash to memory.
[DATA]
Zero and copy the data segment
from flash to memory.
[RELO]
Jump to the new code segment.
[L12F]
Flush and enable caches.
[MAIN]
Jump to the main CFE memory.
[KMEM]
Initialize CRDs heap.
[NVCL]
Clear memory that isn’t owned by
NVMEM or CFE.
[CONS]
Attach console device.
Check the connection between your
appliance and the console device.
Replace the cable if it is defective.
Error message or code
Description
Corrective action
Summary of Contents for FAS200 Series
