![background image](http://html1.mh-extra.com/html/network-appliance/fas200-series/fas200-series_hardware-and-service-manual_1675390056.webp)
44
Configuring for a cluster
11
Test takeover and giveback on
this node by completing the
following steps:
a.
Initiate takeover by
entering the following
command:
cf takeover
Result:
Takeover succeeds. If
not, run the Cluster Configuration
Checker, fix any errors, reboot the
node, and repeat the test.
b.
Check the status of the
takeover using the
cf
status
command.
c.
Give back the node by
entering the following
command:
cf giveback
d.
Check the status of the
cluster using the
cf
status
command.
Test takeover and giveback on
this node by completing the
following steps:
a.
Initiate takeover by
entering the following
command:
cf takeover
Result:
Takeover succeeds. If
not, run the Cluster
Configuration Checker, fix any
errors, reboot the node, and
repeat the test.
b.
Check the status of the
takeover using the
cf
status
command.
c.
Give back the node by
entering the following
command:
cf giveback
d.
Check the status of the
cluster using the
cf
status
command.
Step
Node A action
Node B action
Summary of Contents for FAS200 Series
