![background image](http://html1.mh-extra.com/html/network-appliance/fas200-series/fas200-series_hardware-and-service-manual_1675390062.webp)
50
Configuring the Fibre Channel port
3
Verify that Fibre Channel port 0c is in target mode by entering the following command:
sysconfig
Example:
fas270a> sysconfig
NetApp Release R6.5xN_031130_2230: Mon Dec 1 00:07:33 PST 2003
System ID: 0084166059 (fas270a)
System Serial Number: 123456 (fas270a)
slot 0: System Board
Processors: 2
Processor revision: B2
Processor type: 1250
Memory Size: 1022 MB
slot 0: FC Host Adapter 0b
14 Disks: 952.0GB
1 shelf with EFH
slot 0: Fibre Channel Target Host Adapter 0c
slot 0: SB1250-Gigabit Dual Ethernet Controller
e0a MAC Address: 00:a0:98:01:29:cd (100tx-fd-up)
e0b MAC Address: 00:a0:98:01:29:ce (auto-unknown-cfg_down)
slot 0: NetApp ATA/IDE Adapter 0a (0x00000000000001f0)
0a.0 245MB
Note
Fibre Channel port 0c is identified as Fibre Channel Target Host Adapter 0c.
4
Start the FCP service by entering the following command:
fcp start
Example:
fas270a> fcp start
FCP service is running.
Wed Sep 17 15:17:04 GMT [fas270a: fcp.service.startup:info]: FCP service startup
Step
Action
Summary of Contents for FAS200 Series
