118
Regulatory notices
Regulatory notices
FCC notices
(U.S. only)
NetApp devices are designed for a CFR 47 (Code Federal Regulations) Part 15
Class A environment.
The FCC and NetApp guarantee the user’s rights to operate this equipment only
if the user complies with the following rules and regulations:
◆
Install and operate this equipment in accordance with the specifications and
instructions in this guide.
◆
Modify this equipment only in the ways specified by NetApp.
◆
Use shielded cables with metallic RFI/EMI connector hoods to maintain
compliance with applicable emissions standards.
◆
If the system has nine or more Fibre Channel disk shelves, install the system
in two or three NetApp System Cabinets to maintain performance within
Part 15 of CFR 47 regulations.
Compliance with
Part 15 of CFR 47
This equipment has been tested and found compliant with Part 15 of the CFR 47
rules for Class A digital devices. These rules are designed to provide reasonable
protection from interference to electronics equipment operated in a commercial
environment.
Operation of this device is subject to the following two conditions:
◆
This device cannot cause harmful interference.
◆
This device must accept any interference received, including interference
that may cause undesired operation.
Compliance with
ICES-003
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A conforme à la norme NMB-003 du
Canada.
Compliance with EN
regulations
Marking by the symbol
indicates compliance of this NetApp device to the
EMC Directive and the Low Voltage Directive of the European Union. Such
marking is indicative that this NetApp device meets the technical standards listed
in “Declaration of Conformity,” later in this appendix.
Summary of Contents for FAS200 Series
