Index
123
Index
A
AC power line sizes 116
AC power supplies, connecting appliance to 26
adapter, DB-9 to RJ-45 console 32
ASCII terminal console connection 32, 34
audience, intended for this book vii
B
backup firmware image, booting from a 109
battery, replacement of 86, 87
blank filler module 68
boot messages 97
booting your cluster 41
C
cluster configuration tasks 36
commands
cf enable (enables clustering) 92
cf giveback (enables giveback) 94
cf takeover (enables takeover) 93
CompactFlash card
configuring for a cluster 36
configuring the Fibre Channel port 48
connections
appliance 1
ASCII terminal console 32, 34
clustered disk shelf 19
clustered network 8
console 32, 34
disk shelf 12
Fibre Channel switch 30
nonclustered disk shelf 13
nonclustered network 3
power 26
storage appliance to power source 26
tape backup device 28
third-party device 27
conventions
command viii
formatting viii
keyboard ix
CPU module
battery pack 68, 87
contents of a 68
hot-swapping a 79
installation of a 75
interpreting LEDs on a FAS270/270c 61
location of Ethernet LEDs 61
location of Fibre Channel LEDs on the
location of LEDs on the 61
location of LEDs on the FAS250 63
location of the 68
reasons for removing a 69
removing a 70
replacement of a 68
terminate switch on a 6, 10
D
DB-9 to RJ-45
console adapter 32
pin connections 32
device carrier vii
DIMMs
replacement of 81
required memory configuration for 81
disk ownership worksheet 40
disk reservation and ownership
Data ONTAP 6.5.0 or earlier 38
Data ONTAP 6.5.1 or later 39
installation of 67
interpreting LEDs on 60
location of LEDs on 59
reasons for replacing 66
removal of 66
spin-up time for 26
Summary of Contents for FAS200 Series
