Chapter 1: Connecting a FAS200 Series Appliance
19
Connecting additional disk shelves
Connecting disk shelves to a FAS270c
Clustering
terminology
For clustering, the CPU modules are referred to as “nodes.” Node A is the top
CPU module at the rear of the appliance, and Node B is the bottom CPU module.
Connecting disk
shelves to a
clustered system
To connect additional disk shelves to your clustered FAS270c, complete the
following steps.
Node B
Terminate switch
Terminate switch
Node A
Step
Action
1
Put on the antistatic wrist strap and grounding leash, and then take over
the target node and turn off the system.
2
Take over the target node, and then shut down the target node.
Note
You can hot-add a disk shelf to your system. See the
DiskShelf14,
DiskShelf14mk2 FC, and DiskShelf14mk4 FC Hardware and Service
Guide
for information about hot-adding a disk shelf to your system.
Summary of Contents for FAS200 Series
