Chapter 4: Replacing FAS200 Series Devices
81
Replacing the SDRAM DIMM on the CPU module
About replacing
SDRAM DIMMs
The SDRAM DIMM is on the CPU module motherboard. You must remove the
CPU module from the chassis before replacing the DIMM.
Required memory
configuration
The FAS270/FAS270c supports 1 x 1 GB, 2.5V 184P DDR SDRAM DIMM. The
DIMM slot is inside the CPU module.
The FAS250 supports 1 x 512 MB, 2.5V 184P DDR SDRAM DIMM. The
DIMM slot is inside the CPU module.
Caution
All DIMMs must be listed on the NetApp Approved Parts List. Contact NetApp
Sales to obtain this list. Unapproved DIMMs have not been tested for reliability
and might cause system downtime.
Replacing the
SDRAM DIMM
To remove the SDRAM DIMM, complete the following steps.
Step
Action
1
Perform a clean system shutdown before removing the DIMM.
Caution
Removing the DIMM without first performing a clean system
shutdown can result in data loss.
2
Remove the CPU module containing the DIMM to be replaced.
Follow the procedure in “
3
If you don't have the antistatic wrist strap and grounding leash on
from the previous step, put it on now.
4
Unplug the battery pack from the motherboard before removing the
DIMM. For the location of the battery pack and cable connection, see
the illustration in
Summary of Contents for FAS200 Series
