SmartNA-X 1G/10G Modular | Working with the V-Line Module |
65
SmartNA-X
™
1G/10G User Guide 1.4
©
2015 Network Critical Solutions Limited
Note:
Slicing applies to the ingress traffic mapped to other system ports, not to the Live Ports themselves.
4.
Configure port communication settings, noting the following requirements for effective port communications:
Mapping to other TAP modules
If a V-Line module is mapped to another TAP module, the V-Line module ports must be set to 1G bps.
Live ports
If operating in V-Line, Aggregation or Breakout mode, the V-Line module live ports (
A
and
B
) must have
matching communication settings (same speed, duplex and MDI settings).
Tool ports
If operating in V-Line or Breakout mode, the V-Line module tool ports (
C
and
D
) must have the same
communication settings as the live ports (
A
and
B
) .
5.
Click
Review/apply
and review pending changes. To apply these changes to the system, click
Apply changes
or click
'
X
' to cancel.
Figure 58: V-Line Module: V-Line mode settings dialog
Configure Breakout mode
1.
Click on the V-Line module you wish to configure and select the
V-Line
tab.
2.
From
V-Line mode
, select
Breakout
. The
V-Line Module: Breakout mode
dialog is displayed (see the figure below).
Figure 59: V-Line Module: Breakout mode settings dialog
3.
Enter values for the parameters.
