NetworX Architech, Mounting And Installation Instructions Manual

1 

ArchiTech Cylindrical Lock & Surface-Mounted Networx Control Unit Mounting and Installation Instructions 

ArchiTech

™

 by Networx

™

FOR CYLINDRICAL LOCKS USING SURFACE-MOUNTED NETWORX CONTROL UNITS  

MOUNTING AND INSTALLATION INSTRUCTIONS 

© NAPCO Security Technologies, Inc. 2016 

WI2104B  09/16 

DESCRIPTION 

These instructions detail the hardware installation procedure for the ArchiTech 

cylindrical door locks 

using the 

Surface

-Mounted Networx Control Units 

for hollow metal and solid wood doors.   

Installation instructions for the 

Door Contact Sensor

, 

Door Contact Magnet

 (installed in the door jamb) and the 

Oval 

and 

Rectangular Proximity Readers 

are also included.   

PARTS OVERVIEW 

For reference, the images in Fig. A display each component (not to scale).  In addition to the various screws and tem-
plates included with your lock, please note that one of two types of 

Proximity Readers 

are included, either 

Oval

 or 

Rectangular

.  In addition, one of two types of 

Door Contact Magnets

 (installed in door jamb) are included, ei-

ther 3/8" or 3/4" diameter.   

Wires for the 

Door Contact Sensor

, 

Proximity Reader

 and 

Cylindrical Lock

 motor are routed through the door 

and are plugged into the rear of the 

Surface-Mounted Networx Control Unit

, mounted on the inside (" protected" ) 

door surface. 

 
 The 

Cylindrical Lock Motor Wire

 can be routed within hollow metal doors; with solid wood doors, this 

Cylindrical Lock 

Motor Wire

 can be routed on the door surface but behind a 

Wiring Plate 

(HW1945), or an optional 

Cylindrical 

Drill Jig

 (part #N90S1DJ) is available to allow a hole to be drilled allowing this wire to be routed through the 

solid wood door.   

REQUIRED TOOLS 

In addition to the standard door prep kit tools used to install a cylindrical lock into a metal or wood door (standard ASA 
161 door prep cross-bore hole saws, Phillips and flat head screwdrivers, etc.), you will need:  A small 

level

, and the 

following drill bit sizes:  

5/8"

, 

3/8"

, 

3/4"

 and 

7/64"

.  If the 

Cylindrical Drill Jig

 (part #N90S1DJ) is used, a 

round or cir-

cular file

 is needed to remove burrs in holes and to file a pathway groove in wooden doors for the 

Cylindrical 

Lock Motor Wire

.   

IMPORTANT:

  For installation on UL Listed Wood Fire Doors, fill the through hole wire passage with UL Clas-

sified Fire Stop Sealant after connecting all wiring and testing the Lock. 

FIG. A:  OVERVIEW OF BASIC PARTS (NOT TO SCALE) 

"SURFACE-MOUNTED" NETWORX 

CONTROL UNIT  

AND ITS MOUNTING PLATE 

OVAL AND RECTANGULAR  

PROXIMITY READER COVERS AND 

MOUNTING COMPONENTS 

USE WIRING PLATE (LEFT) 

OR OPTIONAL CYLINDRICAL 

DRILL JIG (RIGHT) 

OR 

DOOR CONTACT  

MAGNET  

(TWO TYPES) 

OR 

DOOR 

CONTACT 

SENSOR