ArchiTech Cylindrical Lock & Surface-Mounted Networx Control Unit Mounting and Installation Instructions
12
12B. CLAMP DRILL JIG TO DOOR
On the inside ("protected") side of the door, place the
Jig
(
Alignment Puck
first), into the 2-1/8" diameter door
chassis hole. Use a level to ensure the top edge of the
Jig
is horizontal; then clamp the
Jig
in place (temporarily
cushion the clamp(s) with shims or other material to prevent damaging the door surface, as shown in Fig. 12BB).
12C. DRILL HOLE WITH DRILL JIG
Insert supplied 1/2-inch diameter wood drill bit into the
Cylindrical
Drill Jig
as shown in Fig. 12C and drill the hole until the 2-1/8"
diameter door chassis hole is reached.
When finished, remove the
Jig
.
FIG. 12C: DRILL SLOWLY AND
CAREFULLY
FIG. 12B: DRILL JIG CLAMPED TO DOOR, WITH LEVEL
FIG. 12BB: ALWAYS PROTECT THE
DOOR SURFACE !
