ArchiTech Cylindrical Lock & Surface-Mounted Networx Control Unit Mounting and Installation Instructions
14
12F. INSTALL THE "CYLINDRICAL LOCK BODY"
From the outside ("unprotected") side of the door, insert the
Cylindrical Lock Body
into the 2-1/8" diameter door
chassis hole while feeding the
Cylindrical Lock Motor Wire
up through the 5/8" diameter thru-hole running to the
inside ("protected") side of the door.
Note:
The
Cylindrical Lock Motor Wire
plug sleeve color is
yellow
.
Secure
the
Cylindrical Lock
with the mounting hardware provided. See the installation instructions provided with
the
Cylindrical Lock
for complete installation instructions.
13. INSTALL "DOOR CONTACT SENSOR" IN DOOR EDGE
Insert
the
Door Contact Sensor
wires through its 3/4" hole in the edge of the door and then out through the 5/8" diameter
thru-hole to the inside ("protected") side of the door.
Note:
The
Door Contact Sensor
plug wires are
white
.
FIG. 12F: INTERIOR HOLE (ARROW)
FIG. 13: ROUTE TO THE INSIDE
("PROTECTED") SIDE OF THE DOOR
FIG. 13A
DOOR CONTACT SENSOR
