NetworX Architech, Mounting And Installation Instructions Manual

ArchiTech Cylindrical Lock & Surface-Mounted Networx Control Unit Mounting and Installation Instructions 

18 

15C.  INSTALL RECTANGULAR PROXIMITY READER COVER  

 The 

Rectangular Proximity Reader

 cover "snaps" into place, as follows: 

a. Hook 

the 

Rectangular Proximity Reader

 on the two 

Top Tabs

 on the top of 

the 

Rectangular Mounting Plate

 (see Fig 15C).   

b.  Press firmly on the bottom of the 

Rectangular Proximity 

Reader

 until it " snaps"  into place.   

Be careful not to pinch any wires.  

16. INSTALL "CONTROL UNIT MOUNTING PLATE"

Locate the two pilot holes for the 

Control Unit Mounting Plate

 mounting screws 

that were drilled into the inside ("protected") door surface in step 8. 

See Fig 16 to determine which end is the "TOP".  Place the 

Control Unit Mounting 

Plate

 against the inside (" protected" ) door surface and secure using the two 

Phillips Flat Head screws appropriate for the door type as follows:   



For Metal Doors:

  #6-32 x 5/8" long Type 23 thread 

cutting Phillips Flat head, U-cut (part #SC682); 



For Wood Doors:

   #6 x 3/4"  long undercut self-

tapping Type A (part #SC596) 

If the 

Wiring Plate

 was installed in step 11, remove the 

screws previously installed in step 11E that hold the 

Wiring Plate

 against the door.  Place the 

Control 

Unit Mounting Plate

 on top of the 

Wiring Plate

 and 

re-install the screws (see Fig. 16A).    

FIG. 15CC 

FIG. 15C 

FIG. 16:   

CONTROL UNIT MOUNTING 

PLATE 

(TOP) 

(BOTTOM) 

FIG. 16A:  INSTALL CONTROL 
UNIT MOUNTING PLATE ON TOP 
OF WIRING PLATE, IF INSTALLED