ArchiTech Cylindrical Lock & Surface-Mounted Networx Control Unit Mounting and Installation Instructions
2
DOOR PREP: INITIAL STEPS
1. INSPECT THE DOOR BEVEL
Inspect the door for a bevel and, if beveled, determine which side is "longer" in width and which side is "shorter" in
width (see "top view" example in Fig. 1). For beveled doors, be sure to use the correct marks printed on the template
for the correct length of the outside door surface (either the "long" or "short" side of the door).
2. PREP DOOR FOR CYLINDRICAL LOCK
If not done already, use standard door prep kit tools and the instructions included with the cylindrical lock to prep the
door and door jamb as required (standard ASA 161 door prep). These include the 5/16" and 2-1/8" thru-holes, the 1"
latch hole and mortising the door edge for the latch plate and mortising the door jamb for the strike plate.
Do not install the lock hardware yet.
DOOR
3½° bevel
Door Stop
Arc of door swing
Jamb
"Shorter side of
door"
"Longer side of
door"
FIG. 1: EXAMPLE OF BEVELED DOOR (TOP VIEW)
FIG. 2: USE TEMPLATE PROVIDED
