5
ArchiTech Cylindrical Lock & Surface-Mounted Networx Control Unit Mounting and Installation Instructions
7. TAPE ON DOOR: "SURFACE-MOUNTED NETWORX CONTROL UNIT"
TEMPLATE (WI2099)
The
Surface-Mounted Networx Control Unit
(see Fig. A on page 1) is al-
ways mounted on the inside ("protected") door surface.
Fold and place the template (WI2099) on the
inside door edge
. Align the
template with the "
HORIZONTAL CENTER LINE OF LEVER
" and the 5/8"
diameter thru-hole as shown on the template. Tape the template in place.
8. MARK TEMPLATE "SURFACE-MOUNTED NETWORX CONTROL UNIT" HOLES
On the inside ("protected") door surface, mark the two
Control Unit Mounting Plate
(Fig. 8) holes using the correct mark-
ings printed on the template (if door is beveled, use correct markings for beveled doors as described in step 1).
The center of the 5/8" diameter thru-hole was already marked on the outside surface in step 4; for the inside door sur-
face, mark the center of the 5/8" diameter thru-hole. This 5/8" diameter thru-hole is used for the
Cylindrical Lock Motor
Wire
,
Proximity Reader
and
Door Contact Sensor
wires.
Carefully remove the template.
FIG. 7: EXAMPLE OF INSIDE
DOOR EDGE (ARROW)
FIG. 8: MARK THE TWO "CONTROL UNIT
MOUNTING PLATE" HOLES (ARROWS)
