ArchiTech Cylindrical Lock & Surface-Mounted Networx Control Unit Mounting and Installation Instructions
6
DOOR PREP: DRILL HOLES
IMPORTANT:
Remove all burrs from wire holes.
Sharp edges can eventually wear away wire insulation
.
9. DRILL THE FOLLOWING HOLES IN THE DOOR
9A.
Use
7/64"
drill bit:
On the outside ("unprotected side")
door surface, drill the two pilot
holes for the
Proximity Reader
mounting screws (NOT thru-holes,
drill only into the door surface).
9B.
Use
7/64"
drill bit:
On the inside ("protected side")
door surface, drill the two pilot
holes for the
Control Unit Mounting
Plate
mounting screws (NOT
thru-holes). Drill only into the in-
side door surface.
9C.
Use
5/8"
drill bit:
5/8" diameter thru-hole
.
Drill
straight
through the door
.
9D.
Use
3/4"
drill bit: 3/4"
Door Contact
Sensor
hole in edge of the door
(for solid wood doors, drill until the
hole intersects with the 5/8" diameter
thru-hole).
FIG. 9A: 7/64" PILOT HOLE ON
OUTSIDE DOOR SURFACE FOR
PROXIMITY READER
FIG. 9B: 7/64" PILOT HOLE ON
INSIDE DOOR SURFACE FOR
CONTROL UNIT PLATE
FIG. 9C:
5/8" DIAMETER THRU-HOLE
(5/8" DIAMETER
THRU-HOLE,
DRILLED IN
STEP 9C)
(CYLINDRICAL
LOCK PREP,
STEP 2)
"DOOR CONTACT SENSOR" HOLE
(3/4") IN EDGE OF DOOR
FIG. 9D: 3/4" DOOR CONTACT SENSOR HOLE IN EDGE OF THE DOOR
