g)
Use the power tool, accessories and tool bits etc., in accordance with these instructions and in the manner intended for the
particular type of power tool, taking into account the working conditions and the work to be performed.
Use of the power tool
for operations different from those intended could result in a hazardous situation.
5) SERVICE
a)
Have your power tool serviced by a qualified repair person using only identical replacement parts.
This will ensure that the
safety of the power tool is maintained.
SAFETY INSTRUCTIONS FOR TACKERS
·
Secure the work piece
(a work piece clamped with clamping devices or in a vice is held more securely than by hand)
·
Never press contact safety switch with your hand 4.
(there is danger of injury when at the same time the trigger is
activated unintentionally)
·
Never use the tool for fastening electrical wiring
(contact with electrical wires can lead to fire and electric shock)
·
Avoid damage that can be caused by screws, nails and other elements in your work piece; remove them before you start working
·
Always check that the supply voltage is the same as the voltage indicated on the nameplate of the tacker (tackers with a rating of 230V
or 240V can also be connected to a 220Vsupply)
·
In case of electrical or mechanical malfunction, immediately switch off the tool.
·
PRULDE can assure flawless functioning of the tool only when original accessories are used
·
This tool should not be used by people under the age of 16 years
·
Do not expose tool to rain.
5
USE
·
Loading staples/nails
6
- turn tool up side down
- press the both side of locker A and pull the slider backwards
- insert the staple/nail strip into magazine C with legs facing upward (maximal capacity 84 staples/nails)
- push slider B against tacker head until it snap- locks
- when inserting a nail strip tilt the tool in such a way, that the nail strip rests against the magazine side
which corresponds with the nail symbol on tacker head
7
- Operating the tool
8
- firmly press Contact safety switch D against the workpiece until it is pushed in a few millimeters
- pull the trigger F to fire the staple, then release the trigger
- The tool will lock as long as you do not press
the contact safety switch against the workpiece surface, thus prevent accidental firing
- At 20 shots/min, tacker should be allowed to cool down after 30 minutes continuous firing as it is only rated for short-time duty.
! remove all staples/nails from the magazine after each use
·
Impact control
9
With wheel G the required impact level can be selected in steps
- indicator G shows the selected impact level
-
“
-
” for thin and light materials such as foils and fabrics
-
“+” for thick and tough materials such as hard woods and
walls
- before starting a job, find the optimal impact level by testing out on spare material
APPLICATION ADVICE
·
Fastening panels
10
·
Do not use the tool for fastening ceiling panelling on profiled wood or grooves
·
Fixing textiles
11
·
Avoid dry fire in order to reduce the wear of the impact strike
GUARANTEE / ENVIRONMENT
·
Keep tool clean
! unplug power cord from power source before cleaning
·
This product is guaranteed in accordance with statutory/country-specific regulations; damage due to normal wear and tear, overload
or improper handling will be excluded from the guarantee
·
Do not dispose of electric tools,
accessories and packaging together with household waste material
(only for EU countries)
- in observance of European Directive 2002/96/EC on waste of electric and electronic equipment and its implementation in
Summary of Contents for NTC0060-EU
Page 3: ...3 7 8 D 3 C B 2 A 1 1 6 ...
Page 4: ...4 12 10 11 ...
