Neue SFO2SS, User Manual

1

2

7

 Carefully lift (step 1)

and remove (step 2) the
glass panel.

Clean the glass panel with water and soap. Dry the
glass panel carefully.

Installing the door and the glass panel

When the cleaning is completed, install the glass panel
and the oven door. Do the above steps in the opposite
sequence.

The screen-printing zone must face the inner side of the
door. Make sure that after the installation the surface of
the glass panel frame on the screen-printing zones is
not rough when you touch it.
Make sure that you install the internal glass panel in the
seats correctly. Refer to the illustration.

What to do if…

Warning!

 Refer to the Safety chapters.

Problem

Possible cause

Remedy

The oven does not heat up.

The appliance is deactivated.

Activate the appliance.

The oven does not heat up.

The clock is not set.

Set the clock.

The oven does not heat up.

The necessary settings are not set.

Make sure that the settings are cor-
rect.

The oven does not heat up.

The fuse in the fuse box is released. Do a check of the fuse. If the fuse is

released more than one time, con-
tact a qualified electrician.

The oven lamp does not operate.

The oven lamp is defective.

Replace the oven lamp.

The display shows 

12.00

.

There was a power cut.

Set the clock.

Steam and condensation settle on
the food and in the oven.

You left the dish in the oven for too
long.

Do not keep the dishes in the oven
for longer than 15 - 20 minutes after
the cooking ends.

If you cannot find a solution to the problem yourself,
contact your dealer or the service centre.

The necessary data for the service centre is on the rat-
ing plate. The rating plate is on the front frame of the
appliance cavity.

We recommend that you write the data here:
Model (MOD.)

.........................................

14