Remember:
when the control lamp goes on - the unit is being heated when the control lamp goes off -
the selected heat has been reached.
The desired temperature is set by turning the regulator clockwise. The max. temperature is
300 °C.
Timer :
The desired baking time can be set by turning the regulator on the scale.
The numbers indicated on the scale are not exactly one minute; they are only directive figures
corresponding to approx. 1 minute. Once the approx. time has been selected, the release
button is pressed, and time runs down until an acoustic signal is given. The timer is ready for
operation as soon as the unit has been switched on by means of the main switch
3. Maintenance and cleaning
Important:
Disconnect unit from the power supply and wait until the unit has cooled down
before you begin with any maintenance or cleaning procedures.
3.1 Cleaning instructions
Food residues or spots on the surfaces have to be cleaned immediately and if possible in
warm condition (make sure not to burn yourself as the units could still be hot) or at the latest
before operation.
Use a dry cloth, tissues or a brush for cleaning if only slight residues have to be removed If
persistent residues have to cleaned, we recommend you to use a spatula or a wire brush for
cleaning the
uncoated plates
.
The
Teflon-coated plates
should only be cleaned by means of a cloth or a bristle brush. Do
not use any abrasive detergents. Never clean the unit and the installed baking plates with
water. If the afore-mentioned utensils do not achieve satisfying cleaning results, wait until the
plates have cooled down and clean the plates by using appropriate detergents, but not abrasive
cleaners.
4. Faults - repairs
Regulator faults:
If the control lamp remains on, the regulator might be defect. In this case the unit will be heated
continuously for a period longer than 30 minutes.
Heating element faults:
The unit does not become hot although the regulator and the lamp have been switched on for
more than 30 minutes.
In these two cases, please disconnect the unit from the power supply / pull out the plug.
Contact our service department and never try to repair the unit by yourself.
A defective timer has no influence on the grilling procedure which is operated by the heating
elements and the regulator. This means that you will be able to continue your grilling
procedures. We advise you, however, to consult a specialist to exchange the defective timer.
