Spate cleaner TANKO-SF
1 Introduction
Translation of the original Operating / Installation Instructions 2016/09 Rev.1 1/63
1
Introduction
These operating/installation instructions (referred to hereinafter as the instructions) are a component
part of the device. They provide you with all the information required for smooth operation of the
TANKO
®
SF spate cleaner (referred to hereinafter as the device).
The instructions must be read, understood, and applied by all persons employed to carry out installation
and assembly, maintenance, cleaning and troubleshooting on the device. This applies in particular to
the listed safety notes.
After studying the instructions, you will be able to
–
assemble, install and operate the device safely,
–
clean and service the device correctly and
–
take the correct measures if a fault occurs.
In addition to these instructions, generally valid, statutory and other binding regulations in regard of the
prevention of accidents and in regard of environmental protection in the country of use must also be
observed.
The instructions must be kept at the location of use of the device so that it is available in legible condition
at all times. If the device is resold, the instructions must always be transferred to the new owner.
Download the instructions if necessary from the
http://www.awh.eu/de/downloads
1.1
Means of Presentation
1.1.1
Explanation of Signal Words
The warnings are introduced with a signal word which describes the extent of the hazard. The meaning
and their classification in case of hazardous situations are explained in the following overview.
Signal Word
Meaning
Consequences of Failure to Observe
DANGER
Hazard
with a high level of risk
Death or severe physical injuries
WARNING
Hazard
with a medium level of risk
Death or severe physical injuries
CAUTION
Hazard
with a low level of risk
Minor or moderate physical injuries
NOTE
Hazard
with a low risk
Risk of material damage
Table 1.1-1: Overview of Signal Words
