NEUTON
Corded Pole Saw
-
Safety & Operating Instructions
9
Chapter 5: Troubleshooting Your NEUTON Corded Pole Saw
Troubleshooting Tips
Most difficulties are easy to fix. Consult the Troubleshooting Table for common problems and their solutions. If you continue to experience
problems or need repairs beyond these minor adjustments, visit our website at
www.neutonpower.com
or call Neuton Power Equipment. Toll
Free at:
1-866-NEUTON1 (638-8661)
for assistance.
Always unplug the power cord before performing any adjustments, maintenance, or repairs to your Pole Saw.
Troubleshooting Table
P
ROBLEM
C
ORRECTIVE
A
CTION
The Saw Motor fails
to start.
⇒
Check that you installed the power cord properly into the Pole Saw power cord receptacle and you
plugged the power cord into a live 120V outlet.
⇒
Make sure that you fully push in the Lock-Off Button before squeezing the ON/OFF Trigger Switch.
The Saw runs, but
the Chain speed Is
low.
⇒
The Chain is too tight, re-tension.
Bar and Chain
running hot and
smoking.
⇒
The Chain tension is too tight, re-tension.
⇒
The Chain Oil Tank is empty, refill.
⇒
The lubrication holes are plugged, clean them out.
The Saw Motor runs,
but the Chain is not
turning.
⇒
The Chain tension is too tight, re-tension.
⇒
The Guide Bar or Chain is damaged, inspect and replace the damaged part.
