alignment again. Pay attention to IC polarity! Also, you may need to
bend the IC’s legs the tiniest bit to make it fit.
Next step: panel
Now to place all components in their respective holes on the panel.
You’ll need:
Bill of Materials - Panel
Part
Type
Notes
TIME, MIX,
FEEBACK, MOD,
TUNE (x3)
10 k
Ω
B
You may use higher values, like 22 k
Ω
or
25 k
Ω
, but not higher than that.
Lower than
10 k
Ω
is not recommended. B
means linear.
FILTER, VOLUME,
SCRATCH
10 k
Ω
B
You must use this exact value, although
you could use A (logarithmic) if you
prefer a different response curve.
Power LED
3 mm blue
LED
The hole for the socket is 6 mm.
Env LED (x3)
3 mm orange
LED
The holes for the sockets are 6 mm.
Power switch
SPDT The hole is 6 mm.
ENV switches
(x3)
SPST The holes are 6 mm. You may use SPDT as
well.
SHAPE switches
(x3)
SPST The holes are 6 mm. You may use SPDT as
well.
BITE switch
SPST The hole is 6 mm. You may use SPDT as
well.
Touch pads (x6)
The holes are 5 mm. Make sure to use
plastic washers at least on the front
side, so that the pads do not come into
contact with the gold plating!
