Now plug in and test your module.
Refer to the manual if needed.
If something’s not right, it may
be best to unplug the module from
Eurorack power immediately so as
not to damage the PSU.
Most problems can easily be fixed
by reheating all solder joints so
the
solder
can
reflow.
Also
visually inspect joints and see if
you
can
spot
accidental
solder
bridges.
When
everything
is
working
correctly,
you
can
add
the
remaining
washers
and
tighten
them. If using a wrench or pliers,
be
careful
not
to
scratch
the
front panel surface.
As the final step, put the knobs
on the pot shafts.
If you need help troubleshooting or want to share photos, audio and/or
video
of
your
creations
(please
do),
send
a
message
to
