New Air Refrigeration
MAINTENANCE
MAINTENANCE
10
NGR Series: Maintenance
WARNING—Disconnect power cord before cleaning any parts of the unit.
Maintenance
: Please clean the cabinet with a soft cloth regularly. Please disconnect the unit prior to
cleaning. When the cabinet will not be used for a long time, disconnect the power cord then clean it.
Please examine the wiring circuit before reusing it.
Restart
: Please wait 5 minutes to restart the refrigerator after disconnecting the power or it will affect
the life of the compressor. To save energy, the unit drawer should not be frequently opened or left open
for a long time.
REGULAR MAINTENANCE
Cleaning the condenser coil
For efficient operation, it is important that the condenser surface be kept free of dust, dirt, and lint. New
Air recommends cleaning the condenser coil and fins at least once per month. Clean with a commercial
condenser coil cleaner, available from any kitchen equipment retailer. Brush the condenser fins from top
to bottom, not side to side. After cleaning, straighten any bent condenser fins with a fin comb.
Cleaning the fan blades and motor
If necessary, clean the fan blades and motor with a soft cloth. If it is necessary to wash the fan blades,
cover the fan motor to prevent moisture damage.
Cleaning the interior of unit
When cleaning the cabinet interior, use a solvent of warm water and mild soap. Do not use steel wool,
caustic soap, abrasive cleaners, or bleach that may damage the stainless steel surface.
Cleaning the back panel:
1.Take down the setscrews of the back panel one by one manually, and then take down the back panel.
2.Clean the backboard behind the panel by scour, pay attention to keep the safety of the heat
preservation material covered by the cupreous tube, clean the parts around the motherboard holes,
clean the back of the panel, dry the cleaning parts by soft cloth.
3.Fix the back panel on the cabinet after cleaning is done.
Wash door gaskets on a regular basis, preferably weekly. Simply remove door gasket from the frame of
the door, soak in warm water and soap for thirty (30) minutes, dry with soft cloth, and replace. Check
door gaskets for proper seal after they are replaced.
