M6 x 15mm phillips bolts
M6 washers
6
STEP 2 – Back Rest and Seat
Cushion Assembly
replace bolt from
bottom side up
into square holes
on rear foot tube
replace washer
and nut from top side
replace washer
and nut from top side
rear foot tube
assembly shown
(no roller on
rear foot tube)
rear of unit
STEP 1 – Foot Tube Assembly
Remove the two Carriage Bolts, Washers and Nylon
Nuts from both the Front Foot Tube with Rollers and
the Rear Foot Tube with Caps.
Align the Rear Foot Tube with the rear of the Main
Frame Assembly. Make sure the square holes in the
Rear Foot Tube are on the outside. Insert Bolt
through the Rear Foot Tube and Main Frame
Assembly. Secure with Washers and Nuts you
just removed. Tighten with
the Wrench provided.
Repeat on the front of the
unit using the Front Foot
Tube
with Rollers
.
1
main frame
assembly
rear of unit
front of unit
a)
Place the Seat Carriage Slider on the
Back Rest with the Seat Carriage
Bushing toward the top of the Back
Rest. Secure with the Phillips Bolts,
Washers and Hex Nuts from your
Fastener Pack. Tighten bolts with the
Wrench provided.
b)
Place the Seat Cushion on a flat surface. Position the Seat
Carriage with the wheels up as shown. Secure with Phillips
Bolts and Washers. Tighten with the Wrench provided. Turn
Assembly over.
c)
Remove the Bolts, Washers and Nuts with Nut Caps from
the Rear Handlebar (the ones with the Pulse Sensors).
Position the Handlebar into the notch on the Seat
Carriage, making sure the wires are facing down and
the Pulse Sensors are facing up. Replace the Bolts,
Washers and Nuts with Nut Caps you just removed.
Tighten with the Wrench provided.
d)
Slide the Back Rest
onto the Seat
Carriage until it
clicks into an
adjustment hole.
Make sure the
wider part of the
Back Rest is toward
the Seat Cushion.
Tighten the
Adjustment Knob.
pulse sensor
wires
seat carriage
rear
handlebar
seat cushion
replace bolts,
washers and
nuts with nut caps
seat
adjustment
knob
seat cushion
back
rest
seat
carriage
locking
knob
seat
carriage
top of back rest
seat carriage bushing
goes towards top of seat
seat carriage slider
2a
2c
seat carriage
underside of
cushion
seat
carriage
locking
knob
2b
2d
M6 x 30mm phillips bolts
M6 washers
M6 hex nuts
