Page | 8
Reset Button
This is for use only as directed by a MoibilEyze support engineer. If inadvertently pressed, the unit can
be reset by removing all power for 20 seconds.
Real-Time Clock
The logger is equipped with a real-time clock that is set at the factory prior to shipping and is maintained
using an internal battery. The battery has an expected life of 10 years but may need to be replaced
sooner. It is safe to open the unit (with the harness removed) to replace the battery. The logger
requires a CR2032 battery.
User Action Button
The user action button is located on the SD side and can be used to insert a [User Action] stamp into the
log file whenever the user desires.
The User Action button can also be utilized to close an active logging session, eliminating the need to
key the system off to close the session. Press and hold the User Action button until the File System LED
turns off. It is safe to remove the SD card when the light goes off. To put the logger back into logging
mode hold the User Action button again until the LED turns or blinks green.
SD Card Slot
The SD Card slot accepts standard SD cards. The system is compatible with most SD Cards with a
maximum capacity of 8GB. The LED’s can be consulted to indicate if the inserted card is supported.
An SD card has been provided and contains security information required for the proof-of-concept to
function. The SD card must be returned with the unit when the evaluation period is complete.
Serial Port
The logger has a serial port that can be used to view detailed trace information from the software. The
information can be useful in troubleshooting problems.
The serial port configuration values are:
Parameter
Value
Baud Rate
115200
Data
8 bit
Parity
None
Stop Bit
1
Flow Control
None
See the
Connector Pins
section of this guide for details about the pins needed to utilize the serial output.