SECTION 00 - GENERAL INFORMATION
00-23
15. Install the jack assembly, 1, between the upper
and lower supports using two pins and retaining
clips.
16. Loosen the front cab mounting bolts, 2, only
enough to allow the bolt to rotate in post. Remove
the rear front cab bolts, 3.
CAUTION
Never remove the front cab bolts, 2, as these are
the pivot bolts during the cab tilting procedure.
Removal of these bolts could cause the cab to fall
and may cause injury and machine damage.
17. Remove the four rear cab post bolts, 4. Note the
number and position of washers for reassembly.
CAUTION
Never loosen or remove any cab retaining
hardware before the jack assembly is installed.
29
18. Jack cab and boom assembly over with the skid
steer properly supported off the ground. Support
the boom at 1 to prevent tipping of the skid steer
when heavy components, engine, hydrostatic
pumps, etc. are removed from the lower frame.
Jack travel or length of hydraulic hoses will limit
the travel of the cab assembly when tilting. Be
sure all wire harnesses, hydraulic hoses, and
throttle cable clear any obstructions during cab
tilting.
WARNING
Never attempt to tilt the skid steer cab without
proper instructions and without using the proper
tool.
CAUTION
Never attempt to operate or move the skid steer
without first installing and properly tightening all
cab retaining hardware.
30
