SECTION 3 -- FIELD OPERATION
3--58
Never have an assistant working the opposite set of
controls. When moving to the opposite set of
controls, move around the tractor or implement. Do
not
cross between the implement and tractor.
The operator must only activate the external
switches while standing to the side of the tractor
(outboard of the rear tyres).
Pressing the upper part of the rocker switch (1) will
cause the lift linkage to raise slowly. Pressing the
lower part will cause the linkage to lower. When the
lower links align with the implement, release the
switch and attach the implement to the 3-point
linkage in the normal way.
To transfer control of the hydraulic power lift back to
the lift control lever, move the lift control lever fully
rearwards and push forward again, more slowly. The
‘hitch enabled’ symbol will display in the instrument
panel, indicating that the 3-point linkage is in phase
with the lift control lever (see page 3--50).
IMPORTANT:
When control of the 3-point linkage is
transferred back to the lift control lever, an attached
implement may raise fully and damage the rear of the
cab. Operator’s should be aware of this and take
appropriate action to stop raising before full lift height
is reached. Adjust the height limit control knob as
described under Position Control Operation.
102
Summary of Contents for T6010 DELTA
