SECTION 3 -- FIELD OPERATION
3--133
WHEEL ADJUSTMENT
The sectioned drawings shown in Figures 229 and 230 illustrate the wheel rim and disc positions at various track
settings. In each table, two track width settings are quoted for each axle type. These are the minimum and
maximum achievable with both wheel assemblies moved fully in (toward the tractor) and fully out (away from
the tractor).
Track Adjustment
Rim and Disc Position
1524 -- 1830 mm (60 -- 72 in.)
1727 -- 2030 mm (68 -- 80 in.)
1930 -- 2235 mm (76 -- 88 in.)
2133 -- 2438 mm (84 -- 96 in.)
229
Wheels with steel centre disc bolted to flange on the rim
NOTE:
With the larger width tyres, it may not be
possible to move the wheels to the narrower settings
due to limited clearance between the tyre and fender.
NOTE:
The track widths shown in Figure 229 are
nominal and may vary from that shown dependent on
wheel and tyre size.
Summary of Contents for T6010 DELTA
