SECTION 4 -- LUBRICATION AND MAINTENANCE
4--58
OPERATION 44
BULB REPLACEMENT
Headlights and Hood--mounted Worklamps
IMPORTANT:
All headlights and worklamps have
halogen bulbs. Never touch a halogen bulb with the
fingers. Natural moisture in the skin mayu cause the
bulb to fail prematurely when switched on. Always
use a clean cloth or tissue when handling halogen
bulbs.
The headlights and two non--adjustable worklamps
are mounted in a moulded unit attached to the front
hood assembly. All bulbs are accessible from the
rear of the lamp unit inside the hood area.
118
To remove bulb from front headlight assembly, raise
hood as previously described in this section. Press
the retaining clip (1) to unhinge the rear part of the
headlight. Detach the retaining spring and remove
the bulb.
To remove the bulb from the integral worklamp
simply rotate the bulb holder assembly (1)
anti--clockwise approximately 20 degrees. The bulb
can then be removed by pressing in the bulb and then
releasing it.
119
Adjustable Worklamps
Grabrail mounted worklamps
To replace the bulbs on the grabrail mounted
worklamps, remove the two retaining screws. Pull
out the lens housing from the main lamp housing.
Squeeze together the ends of the wire retaining clip
(1)
and
pull
the
bulb
holder
from
the
assembly.Remove the bulb making sure to use a
clean cloth or tissue.
120
Summary of Contents for T6010 DELTA
