SECTION 2 -- CONTROLS, INSTRUMENTS AND OPERATION
2--43
Power Take Off Speed
When operating the rear Power Take Off the display
may be used to monitor the output shaft speed. Use
the CAL/SEL button or Enhanced Keypad (where
fitted), to select either rear P.T.O. speed or front
P.T.O. speed (where fitted).
81
3--Point Hitch Position
If your tractor is equipped with Electronic Draft
Control (EDC) the display may be used to show the
position of the 3--point hitch (and implement) by
means of numbers ranging from
’0’
(fully lowered
position) to
’100’
(maximum lift height).
When a front hitch is installed, the display may be
used to show the height of the front lift arms.
’0’
will
represent the fully lowered position,
’100’
the
maximum lift height.
82
DOT MATRIX DISPLAY
A number of tractor operating and set--up functions
may be shown in the Dot Matrix Display (DMD). To
select a function use the CAL/SEL button or the
Enhanced Keypad (where fitted). A symbol will
appear to confirm the function selected.
NOTE:
See page NO TAG for an explanation of
warning and advisory symbols.
If an error occurs in the instrument panel or tractor
systems circuits, a malfunction warning symbol will
appear in this display accompanied by an error code.
Consult your authorised dealer.
83
Summary of Contents for T6010 DELTA
