INTRODUCTION
Safety rules
Safety regulations
Warning and danger symbol
This warning symbol points out important messages con-
cerning your safety.
Carefully read the following safety regulations and ob-
serve advised precautions in order to avoid potential haz-
ards and safeguard your health and safety.
In this manual the symbol is accompanied by the following
key-words:
“WARNING” − Warnings concerning unsuitable repair op-
erations that may jeopardise the safety of repair person-
nel.
“DANGER” − Specific warnings concerning potential haz-
ards for operator safety or for other persons directly or
indirectly involved.
MOLI11K0005AA
1
To prevent accidents
Most accidents or injuries that occur in workshops are
the result of non-observance of simple and fundamental
safety regulations. For this reason, in most cases these
accidents can be avoided: by foreseeing possible causes
and consequently acting with the necessary caution and
care.
Accidents may occur with all types of vehicle, regardless
of how well it was designed and built.
A careful and judicious service technician is the best guar-
antee against accidents.
Precise observance of the most basic safety rule is nor-
mally sufficient to avoid many serious accidents.
“DANGER” – Never carry out any cleaning, lubrication or
maintenance operations when the engine is running.
Safety regulations
General guidelines
• Carefully follow specified repair and maintenance procedures.
• Do not wear rings, wristwatches, jewellery, unbuttoned or loose articles of clothing such as: ties, torn clothing,
scarves, open jackets or shirts with open zips that may remain entangled in moving parts. It is advised to wear
approved safety clothing, e.g: non-slip footwear, gloves, safety goggles, helmets, etc.
• Do not carry out repair operations with someone sitting in the driver’s seat, unless the person is a trained technician
who is assisting with the operation in question.
• Do not operate the vehicle or use any of the implements from different positions, other than the driver’s seat.
• Do not carry out operations on the vehicle with the engine running, unless specifically indicated.
• Stop the engine and ensure that all pressure is relieved from hydraulic circuits before removing caps, covers, valves,
etc.
• All repair and maintenance operations must be carried out using extreme care and attention.
47830952 26/03/2015
3
Find manuals at https://best-manuals.com
